Each file can be reviewed, modified, and saved as needed. For additional information, check Installing your Aura and Configuring your Aura.
Go to the link and download Jessie Server. Once that is done plug everything up. You should'nt need anything in the ribbon cable side as when you jam something in the back side it will essentially crimp the ribbon cable in place. On the root you should have a www. Now, place the www. Get config file for your iOS app. It's a shortcut in the battery charger. So please before starting assembly do the following test : Connect the battery into the battery connector nothing more, let the switch off and nothing else connected.
Then check if the heatsink is getting very hot in few seconds. It should not. If it does get hot while system is OFF and no charger connected please unconnect the battery and contact me for replacing the PCB For the v1. All those issues are because of electrostatic damage. So please especially if you have carpet be carefull. If you have a doubt please handle the PCBs only by the edges and do it with a room without carpet. Although charge may be slow while playing.
D - First boot tips : 1 - When configuring the gamepad at the beginning, when your done with all the controller's buttons you should hold any button to skip the remaining ones. Remove thin plastic with cutter or shard blade 2. On the back panel of the whole device, place your L and R buttons respectively.
They have one post that goes into one hole, this is so that they can swing up and down. This is for the last 2 remaining rubber pieces.
They sort of look like thumbtacks in shape. These go pointy side up and just kind of sit there. They will be secured in place when the two shell halves come together. It will fit perfectly. Now you have to do the all too frustrating task of aligning the backside and front side of the shell together.
I cannot really help too much with this part. Sometimes you may need to adjust the battery or cords. Sometimes the trigger buttons are dumb.
You will eventually get it. While holding it tightly closed with one hand, drop your screws into the holes and then tighten them one by one. Now, using the power button on the back, you should be able to boot into Retropie! It will prompt you with assigning buttons and what not. Have fun! If you have an issue with the font size in Retropie you can do something about that by clicking here.
If you have a white noise issue, do the following. The problem may solve just by opening, moving the wires somewhere else, close again.
Remind maximum output for all USB is 0. If you plug in USB devices that needs more than 0. To solve this if turning off the device is not enought, please turn off, unconnect inner gamepad and any USB device and reconnect. Gamepad going crazy on some buttons? Check that the small round black contact inside the silicone is not dirty and is dust free Check that the silicon are well placed inside the casing.
X button not registering correctly? In order to solve that you can try the following fix : Cutting the upper right corner of the PCB with scissors as showed on enclosed pictures.
This will help the PCB to move a little bit towards the top, enabling a better alignement. Select your currency. EUR Euro.
0コメント